With the support 12 inches up from the bottom of the baffle, lay the assemble on the ground with one set of top anchor screws facing up. Be sure to keep the alignment of the support when pushing it down - the fact that the copper pipe is running through it's center hole and that of the top support should help with this. With a tape measure you should be able to do this fairly accurately - simply push the support down a short ways and measure the distance from the support on the inside of the baffle to the bottom lip - repeat until it is 12 inches inside the baffle. long as this product is used according to our instructions. With the bottom support aligned, and your tape measure ready - push the bottom support into the baffle 12 inches. Your Squirrel Buster Plus squirrel proof bird feeder is guaranteed to be free of material. Before pushing the bottom support into the baffle, align the end grains of the support with the screws in the top support - we will use the top support screw locations to mark where to punch, drill and anchor the bottom support. Now feed the bottom support down the pipe into the bottom of the baffle ( we do this with the pipe as it will help keep everything in alignment ). Locate, Drill & Anchor Bottom Support: Insert the 3/4 inch copper pipe into the now anchored top baffle support. Eliminator Squirrel Resistant Feeder is weight activated to close the seed ports when a squirrel gets on the feeder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |